When configuring a FortiGate in a multi-WAN setup, why would an administrator enable session preservation...

Fortinet FCP_FGT_AD-7.6 Question Answer

When configuring a FortiGate in a multi-WAN setup, why would an administrator enable session preservation on an interface?

To allow the FortiGate to dynamically change interfaces for all active sessions when a WAN link fails

To make sure all sessions without source NAT enabled always use the primary WAN link

To improve security by forcing users to authenticate again when the WAN link changes

To ensure that existing SSL VPN connections remain on the same interface even if route changes occur

FCP_FGT_AD-7.6 PDF/Engine

Get 65% Discount on All Products, Use Coupon: "ac4s65"