Which command assigns an interface to an area?

In RUCKUS ICX switches, assigning an interface to an OSPF (Open Shortest Path First) area involves configuring the interface with the appropriate OSPF area command. The correct command to assign an interface to a specific OSPF area is:

ip ospf area

For example, to assign an interface to area 0, you would enter interface configuration mode for the desired interface and execute:

ip ospf area 0

This command associates the interface with OSPF area 0, enabling OSPF routing on that interface within the specified area.

It's important to note that OSPF areas are logical groupings of networks and routers within an OSPF domain. Assigning interfaces to the correct OSPF areas is essential for efficient routing and network segmentation.

For comprehensive guidance on OSPF configuration, including assigning interfaces to areas, refer to the RUCKUS FastIron Configuration Guide.