Refer to the exhibit.

According to the FortiOS 7.6 Study Guide and the FortiSwitch 7.6 FortiLink Guide , when establishing a FortiLink connection between a standalone FortiGate unit and a single managed FortiSwitch unit, Fortinet supports two valid FortiLink interface architectures:

Single Physical Port (Option A): In basic or entry-level deployments, FortiLink can be enabled directly on a dedicated individual physical interface of the FortiGate (such as a hardware port designated for FortiLink or any unassigned internal Ethernet port). Under this deployment mode, a single physical Ethernet or fiber cable connects the FortiGate physical port directly to the FortiSwitch discovery port.

Link Aggregation Group (LAG) (Option D): Fortinet best-practice architecture recommends configuring the FortiLink interface as an 802.3ad aggregate interface (LAG). Even when connecting a single FortiGate to a single FortiSwitch, a LAG interface can bundle multiple physical links together to provide link redundancy, increased aggregate bandwidth, and seamless scalability for future link additions without disrupting the management tunnel.

Regarding the incorrect options:

Option B (Port channel): " Port channel " is vendor-specific terminology primarily used in Cisco IOS/NX-OS platforms. In Fortinet documentation and GUI/CLI commands, 802.3ad multi-link bundles are strictly defined and configured as 802.3ad aggregate or LAG interfaces.

Option C (Switchport mode trunk): " Switchport mode trunk " is also Cisco syntax. Within Fortinet FortiOS and FortiSwitchOS environments, trunking and tagging behavior is defined by setting the Native VLAN and adding secondary subnets into the Allowed VLANs list on a physical or aggregate interface, rather than using Cisco switchport command modes.