During the Recovery Plan configuration, the administrator maps the " Test Network " setting to...

Nutanix Recovery Plans allow for granular control over networking during different failover scenarios. The " Test Network " setting is specifically designed to provide an isolated sandbox for validation. If an administrator incorrectly maps this test network to the actual " Production Network " VLAN at the recovery site, they are effectively bypassing the safety mechanisms intended to isolate the test.

When the Test Failover is executed, the test VMs will boot up on the production VLAN using the exact same IP addresses they have at the source site. If the primary site is still online (which is the case during a test), the existence of two identical VMs with identical IPs on the same logical network will cause immediate IP address conflicts. This can disrupt live production traffic, cause routing instability, and potentially lead to service outages at both sites. The system does not " automatically " isolate traffic (Option B) if the administrator has explicitly directed the test VMs to the production segment. This scenario emphasizes the critical importance of network planning in BCDR: a " Test " network must always be an isolated, non-routable segment to ensure that validation remains non-disruptive as intended.