You are installing an HCP G10 and are now setting the front-end connectivity.

When installing an HCP G10 and setting up front-end connectivity, two critical actions must be performed on each node:

Set the BMC IP Address (A):The Baseboard Management Controller (BMC) IP address must be set to allow for remote management and monitoring of each node. This is crucial for out-of-band management, especially in large data center environments where physical access to servers may be limited. Configuring the BMC IP address is typically done during the initial setup of the operating system on the HCP node.

Set the Front-End IP Address (C):The front-end IP address, which is used for client network traffic, must be configured as provided by the customer. This IP address allows each node to communicate with the client network, and it is a key part of the configuration during OS installation.

These configurations are detailed in the "HCP G10 Network Configuration Guide" and the "HCP G10 Installation and Configuration Manual," which provide step-by-step procedures for setting up both the BMC and front-end IP addresses.