With the Aruba CX 6000 24G switch with uplinks of 1/1/25 andwhat does the switch...

The correct answer is B. An event log message is created.

The do-not-disable parameter is used to prevent the switch from disabling the port when a loop is detected by the loop-protect feature. Instead, the switch will generate an event log message that indicates the port number and the VLAN ID where the loop was detected.The switch will also send a trap to the SNMP manager, if configured1.

The other options are incorrect because:

A. Port status will not be validated once status is cleared.The port will remain enabled even if a loop is detected, unless the loop-protect action is changed to tx-disable or tx-rx-disable1.

C. The network analytics engine will not be triggered by a loop detection.The network analytics engine is a feature that allows users to monitor and troubleshoot network issues using scripts and agents2.

D. Port status LED will not blink in amber with 100Hz.The port status LED will indicate the normal port status, such as link speed and activity, regardless of the loop detection3.