Which statement correctly describes the factory default on an HPE Aruba Networking CX switch?
A.
Static routing is disabled by default.
B.
VSF stacking is disabled by default.
C.
Default VLAN 1 is created by default.
D.
Multicast routing is enabled by default.
The Answer Is:
C
This question includes an explanation.
Explanation:
The correct answer is C. Default VLAN 1 is created by default. HPE Aruba Networking AOS-CX documentation states that all switch ports are part of access VLAN 1 by default. This confirms that VLAN 1 exists in the factory-default configuration and is the default VLAN used by switch ports. Option B is incorrect because AOS-CX VSF documentation states that users cannot disable VSF and that a factory-default switch boots as a VSF-enabled device with member ID 1 on supported VSF platforms. Option A is not the best answer because static routing is not described as the defining factory-default setting in the same way VLAN 1 is. Static routes are administrator-created route entries, but the clearly documented default behavior in the listed choices is that VLAN 1 exists by default. Option D is incorrect because multicast routing is not enabled by default as a general factory-default behavior. Therefore, the statement that correctly describes the factory default is that default VLAN 1 is created and switch ports belong to it by default.
HPE6-A86 PDF/Engine
Printable Format
Value of Money
100% Pass Assurance
Verified Answers
Researched by Industry Experts
Based on Real Exams Scenarios
100% Real Questions
Get 75% Discount on All Products,
Use Coupon: "ac75sure"