On the network shown in the following figure, a remote LDP session needs to be...

In MPLS LDP, there are two types of sessions:

Direct LDP sessions: Established between directly connected LSRs using LDP Hellos over a link.

Remote LDP sessions (also called targeted LDP sessions): Established between non-directly connected LSRs. These requiremanual configurationof the remote peer.

In this scenario, SWA and SWC arenot directly connected, so aremote (targeted) LDP sessionmust be set up.

For a remote LDP session:

Youmust configure the remote peerusing the command:

[SWA-MPLS-LDP] targeted-peer x.x.x.x

Where x.x.x.x is theLSR ID of SWC(33.3.3.3 in this case).

The current configuration does not include this required step.

Thus, the correct statement is:

D. You need to create a remote peer and specify an LSR ID for the remote peer.