(Which of the following commands needs to be run in the BGP view to enable...

In a VXLAN BGP EVPN deployment, interconnection between Layer 2 and Layer 3 networks relies onIntegrated Routing and Bridging (IRB). According to HCIP Datacom Campus Network documentation, for a VPN instance to advertise its IP routes to the BGP EVPN control plane, the device must explicitly enable IRB route advertisement in the BGP view.

Theadvertise irbcommand is used to allow IP routes learned in a VPN instance to be advertised as EVPN Type 5 (IP Prefix) routes. These routes enable communication between different VNIs or between VXLAN segments and external Layer 3 networks. Without this command, the VPN instance routes remain local and are not distributed through the EVPN control plane, preventing proper Layer 3 connectivity across the VXLAN fabric.

The other options are incorrect in this context. Theadvertise vpnv4command is used in traditional MPLS VPN scenarios, not in BGP EVPN-based VXLAN networks. Theadvertise irbv6command is specific to IPv6 IRB scenarios and does not apply to IPv4 route advertisement unless explicitly required. Theadvertise l2vpn evpncommand is used to enable the EVPN address family itself but does not control the advertisement of IP routes from a VPN instance.

Therefore, to enable a VPN instance to advertise IP routes to the BGP EVPN address family in a VXLAN network, the correct command isadvertise irb.