Which command provides the negotiated port speed of an ethernet port?

On a Pure Storage FlashArray, Ethernet ports operate at both a physical hardware layer and a logical network configuration layer. If you need to verify the actual physical negotiated port speed of an Ethernet port (for example, verifying if a 25GbE port negotiated down to 10GbE due to switch configurations or cable limitations), you must query the hardware layer directly.

The command purehw list --all --type eth interacts directly with the physical NIC hardware components to report their true link status, health, and dynamically negotiated hardware link speed.

Here is why the other options are incorrect:

purenetwork eth list -- all (B): The purenetwork command suite is primarily focused on the logical Layer 2/Layer 3 networking stack. It is used to configure and list IP addresses, subnet masks, MTU sizes (Jumbo Frames), and routing, rather than focusing on the physical hardware negotiation details of the NIC itself.

pureport list (A): The pureport command suite is specifically used for managing and viewing storage protocol target ports. An administrator would use this to list the array ' s Fibre Channel WWNs or iSCSI IQNs to configure host zoning or initiator connections, not to verify Ethernet link negotiation speeds.