When adding a data pack into a FlashArray chassis or a DFS shelf, the drives...

The status "unrecognized" on a drive module typically indicates that the physical hardware is detected by the chassis midplane, but the operating system (Purity) does not have the necessary driver definition or firmware logic to interact with it.

This most commonly occurs when newer generation DirectFlash Modules (e.g., larger capacity drives or newer NAND revisions) are inserted into an array running an older version of Purity. The hardware identifier of the new drive is unknown to the older software .

To resolve this, the Implementation Engineer must verify thePurity Compatibility Matrixfor the specific drive part number. The array will likely need a Purity software upgrade to a version that supports the new media before the drives can be successfully admitted and used. It is rarely a hardware fault (which would show as "failed" or "missing") or a capacity limit (which would prevent admission but usually identify the drive correctly).

=========