After completing an installation, the customer requests to configure replication IP settings.

Configuring replication involves two distinct steps: setting up the physical network interfaces (IP addresses) and then connecting the arrays (partnerships). The question specifically asks where to configure replication IP settings .

In the Purity//FA GUI, the configuration of Ethernet interfaces—regardless of their use for Management, iSCSI, or Replication—is centralized under the Settings tab, specifically within the Network sub-menu.

Settings > Network : Here, the user selects the Ethernet ports (e.g., eth2, eth3) designated for replication and assigns them IP addresses, netmasks, and gateways (or assigns them to a subnet).

Storage > Array Connections : This is where you use those configured IPs to connect to a remote array and establish the replication partnership.

Storage > Replication : This tab is used to monitor replication sessions and manage protection groups (snapshots/policies), not to configure the underlying interface IPs.

=========