Month End Sale Special Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: coponace

Exhibit.

Fortinet FCSS_NST_SE-7.6 Full Course Access
Fortinet FCSS_NST_SE-7.6 View All Questions

Exhibit.

Refer to the exhibit, which contains a screenshot of some phase 1 settings.

The VPN is not up. To diagnose the issue, the administrator enters the following CLI commands on an SSH session on FortiGate:

However, the IKE real-time debug does not show any output. Why?

A.

The administrator must also run the command diagnose debug enable.

B.

The debug shows only error messages. If there is no output, then the phase 1 and phase 2 configurations match.

C.

The log-filter setting is incorrect. The VPN traffic does not match this filter.

D.

Replace diagnose debug application ike -1 with diagnose debug application ipsec -1.

FCSS_NST_SE-7.6 PDF/Engine
  • Printable Format
  • Value of Money
  • 100% Pass Assurance
  • Verified Answers
  • Researched by Industry Experts
  • Based on Real Exams Scenarios
  • 100% Real Questions
buy now FCSS_NST_SE-7.6 pdf
Get 70% Discount on All Products, Use Coupon: "coponace"
Next
Refer to the exhibit, which shows a partial output of the real-time LDAP debug.
Refer to the exhibit.
Previous