Exhibit.

Fortinet FCSS_NST_SE-7.4 Question Answer

Exhibit.

Refer to the exhibit, which contains a screenshot of some phase 1 settings.

The VPN is not up. To diagnose the issue, the administrator enters the following CLI commands on an SSH session on FortiGate:

However, the IKE real-time debug does not show any output. Why?

The administrator must also run the command diagnose debug enable.

The debug shows only error messages. If there is no output, then the phase 1 and phase 2 configurations match.

The log-filter setting is incorrect. The VPN traffic does not match this filter.

Replace diagnose debug application ike -1 with diagnose debug application ipsec -1.

FCSS_NST_SE-7.4 PDF/Engine

Get 65% Discount on All Products, Use Coupon: "ac4s65"