Which two recommendations prevent invalid paths when using zero phase 2 selectors?

" Zero phase 2 selectors " (also known as 0.0.0.0/0 selectors) are commonly used in dynamic VPN environments like ADVPN to allow any traffic to be routed into the tunnel. However, because the selector itself does not define the network range, there is a risk of traffic being sent down " invalid paths " if the routing table is not properly maintained.

Assign tunnel IP: For dynamic routing protocols to function over an IPsec tunnel, the tunnel interfaces must have IP addresses assigned.

Routing protocols: To ensure traffic only follows valid paths, dynamic routing protocols (such as BGP or OSPF) must be used to populate the routing table with the specific prefixes that are actually reachable through each tunnel.

==============