A BIG-IP Administrator is informed that traffic oninterface 1.

On BIG-IP systems,physical interface bandwidth is fixedby the link speed (for example, 1GbE or 10GbE). When traffic demand exceeds the capacity of a single interface, BIG-IP provideslink aggregationthroughtrunks.

Key concepts involved:

InterfacesA single physical interface (such as 1.1) is limited to its negotiated link speed. You cannot exceed this capacity through software tuning alone.

Trunks (Link Aggregation)Atrunkcombines multiple physical interfaces into a single logical interface.

BIG-IP supports LACP and static trunks.

Traffic is distributed across member interfaces, increasingaggregate bandwidthand providingredundancy.

VLANs are then assigned to thetrunk, not directly to individual interfaces.

Why optionBis correct:

Creating atrunk with two interfacesallows BIG-IP to use both physical links simultaneously.

This increases total available bandwidth (for example, two 10Gb interfaces → up to 20Gb aggregate capacity).

This is thedocumented and supported methodfor scaling bandwidth on BIG-IP.

Why the other options are incorrect:

A. Increase the MTUMTU changes affect packet size and efficiency,not total bandwidth capacity.

C. Assign two interfaces to the VLANBIG-IP doesnotsupport assigning a VLAN to multiple interfaces directly. VLANs must be associated withone interface or one trunk.

D. Set the media speed manuallyMedia speed can only be set up to the physical capability of the interface and connected switch port. It cannot exceed the hardware limit.

Conclusion:

To increase total available bandwidth on BIG-IP when a single interface is insufficient, the administrator must create atrunk object with multiple interfacesand move the VLAN onto the trunk. This aligns directly with BIG-IP data plane design and best practices.