Summer Special Limited Time 60% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: 8w52ceb345

After an initial implementation of a SC Fibre Channel front-end, during the failover test one...

EMC DES-1721 Full Course Access
EMC DES-1721 View All Questions

After an initial implementation of a SC Fibre Channel front-end, during the failover test one of the controllers gets reset. All Virtual WWNs from the reset controller are migrated to a single port of the remaining controller.

What corrective action should be taken?

A.

Check cabling, FC Zoning or Fault Domains for incorrect configuration and revise as needed

B.

Incorrect cables used, re-cable as needed

C.

This is the expected behavior and the test completed successfully

D.

FC zoning is not enabled, enable zone config

DES-1721 PDF/Engine
  • Printable Format
  • Value of Money
  • 100% Pass Assurance
  • Verified Answers
  • Researched by Industry Experts
  • Based on Real Exams Scenarios
  • 100% Real Questions
buy now DES-1721 pdf
Get 60% Discount on All Products, Use Coupon: "8w52ceb345"
Next
What is a minimum recommended redundancy to support Controller port level failover?
The storage profile of a volume has changed.
Previous