A Storage Administrator needs to connect through SSH to run svc commands.

The SSH session for a Storage Administrator to run svc commands on a Dell EMC PowerStore system is configured using theAppliance IP address using port 22.

To connect to the service console over SSH, the Storage Administrator should use the appliance IP address.

The default SSH port for accessing the service console isport 221.

SSH access to the nodes may be required for troubleshooting and is not enabled by default. To enable SSH access:

Navigate toSettings.

SelectSSH Managementfrom the Security section.

Choose the appliance or appliances on which to enable SSH.

ClickENABLE SSH1.

The service user account is used for SSH login, and the password is set during the Initial Configuration Wizard (ICW) or can be reset from the PowerStore Manager user interface1.

It’s important to note that the SSH port used to log in to the service container is port 22 after the cluster creation is completed.Before the ICW is run, port 26 may be used1.

For detailed instructions on how to connect to the service console over SSH, please refer to the official Dell documentation or contact Dell Support for assistance.