The requirements for a WLAN you are installing state that it must support unidirectional delays...

VoIP (Voice over Internet Protocol) is an application that is likely used that demands the requirements of unidirectional delays of less than 150 ms and the signal strength at all receivers can be no lower than -67 dBm. VoIP is an application that allows users to make and receive voice calls over a network, such as the Internet or a WLAN. VoIP is a real-time and interactive application that requires high quality of service (QoS) to ensure good user experience and satisfaction. One of the QoS metrics for VoIP is delay, which is the time it takes for a voice packet to travel from the sender to the receiver. Delay can affect the quality and intelligibility of the voice conversation, as well as the synchronization and naturalness of the dialogue. The ITU-T G.114 recommendation suggests that the maximum acceptable one-way delay for VoIP should be less than 150 ms, as anything higher than that can cause noticeable degradation and annoyance to the users. Another QoS metric for VoIP is signal strength, which is the measure of how strong the RF signal is at the receiver. Signal strength can affect the reliability and performance of the wireless connection, as well as the data rate and throughput of the VoIP traffic. The CWNA Official Study Guide recommends that the minimum signal strength for VoIP should be -67 dBm, as anything lower than that can cause packet loss, retries, jitter, and other issues that can impair the voice quality. References: 1, Chapter 10, page 398; 2, Section 6.1