Which three different behaviors must a network designer expect when bidirectional PIM is used instead...

Cisco 352-011 Question Answer

Which three different behaviors must a network designer expect when bidirectional PIM is used instead of PIM Sparse Mode? (Choose three)

The source IP addresses from the multicast senders cannot be seen in the multicast routing table

The RPF check does not prevent routing loops when bidirectional PIM is used

Many possible rendezvous point can be used for bidirectional PIM as compared to PIM Sparse Mode

PIMv2 BSR is not supported with bidirectional PIM

The join messages to join a bidirectional PIM multicast group are different compared to PIM-SM

No rendezvous point is required when bidirectional PIM is used

Auto-RP is not supported with bidirectional PIM

352-011 PDF/Engine

Get 60% Discount on All Products, Use Coupon: "8w52ceb345"