Cyber Monday Sale Special Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: coponace

A security engineer is adding three Cisco FTD devices to a Cisco FMC.

Cisco 300-710 Full Course Access
Cisco 300-710 View All Questions

A security engineer is adding three Cisco FTD devices to a Cisco FMC. Two of the devices have successfully registered to the Cisco FMC. The device that is unable to register is located behind a router that translates all outbound traffic to the router's WAN IP address. Which two steps are required for this device to register to the Cisco FMC? (Choose two.)

A.

Reconfigure the Cisco FMC lo use the device's private IP address instead of the WAN address.

B.

Configure a NAT ID on both the Cisco FMC and the device.

C.

Add the port number being used for PAT on the router to the device's IP address in the Cisco FMC.

D.

Reconfigure the Cisco FMC to use the device's hostname instead of IP address.

E.

Remove the IP address defined for the device in the Cisco FMC.

300-710 PDF/Engine
  • Printable Format
  • Value of Money
  • 100% Pass Assurance
  • Verified Answers
  • Researched by Industry Experts
  • Based on Real Exams Scenarios
  • 100% Real Questions
buy now 300-710 pdf
Get 70% Discount on All Products, Use Coupon: "coponace"
Next
An engineer installs a Cisco FTD device and wants to inspect traffic within the same...
A network administrator is migrating from a Cisco ASA to a Cisco FTD.
Previous