Summer Special Limited Time 60% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: 8w52ceb345

Refer to the exhibit.

Cisco 300-510 Full Course Access
Cisco 300-510 View All Questions

Refer to the exhibit.

After configuring IS-IS on routers R1 and R2, an engineer notices that only the loopback interface at 2000:1::1 /96 is known to router R2. Which change must be made so that only Loopback2 is advertised from R1 to R2?

A.

Configure the router isis areal command under the LoopbackO interface on R1.

B.

Remove the advertise passive-only command under the IS-IS address family ipv6 configuration

C.

Remove the ipv6 router isis areal command under the Loopback2 interface on R1.

D.

Remove the passive-interface Loopback0 command under the router isis areal configuration.

300-510 PDF/Engine
  • Printable Format
  • Value of Money
  • 100% Pass Assurance
  • Verified Answers
  • Researched by Industry Experts
  • Based on Real Exams Scenarios
  • 100% Real Questions
buy now 300-510 pdf
Get 60% Discount on All Products, Use Coupon: "8w52ceb345"
Next
Refer to the exhibit.
Refer to the exhibits.
Previous