Refer to the exhibit.

Cisco 300-410 Question Answer

An engineer is trying to generate a summary route in OSPF for network 10.0.0.0/8, but the

summary route does not show up in the routing table. Why is the summary route missing?

The summary-address command is used only for summarizing prefixes between areas.

The summary route is visible only in the OSPF database, not in the routing table.

There is no route for a subnet inside 10.0.0.0/8, so the summary route is not generated.

The summary route is not visible on this router, but it is visible on other OSPF routers in the same area.

300-410 PDF/Engine

Get 65% Discount on All Products, Use Coupon: "ac4s65"