Why is a first-hop redundancy protocol implemented?
A.
to protect against default gateway failures
B.
to prevent loops in a network
C.
to enable multiple switches to operate as a single unit
D.
to provide load-sharing for a multilink segment
The Answer Is:
A
This question includes an explanation.
Explanation:
to protect against default gateway failures. Switching questions depend on MAC learning, VLAN membership, trunking, STP election, and EtherChannel behavior. Cisco CCNA 200-301 v1.1 includes this under IP Connectivity, where the expected skill is selecting the feature that actually produces the requested network behavior. The wording normally gives the clue: protocol family, address scope, trunk state, route preference, security mode, API method, or controller role. Wrong answers misapply a Layer 2 rule or configure the wrong logical interface. In production, choosing the wrong option would typically cause failed client access, a broken route, insecure management, or an automation workflow that targets the wrong interface. The selected answer is the Cisco-consistent behavior for this item.
200-301 PDF/Engine
Printable Format
Value of Money
100% Pass Assurance
Verified Answers
Researched by Industry Experts
Based on Real Exams Scenarios
100% Real Questions
Get 75% Discount on All Products,
Use Coupon: "ac75sure"