Refer to Itie exhibit A network engineer started to configure port security on a new...

Cisco 200-301 Question Answer

Refer to Itie exhibit

A network engineer started to configure port security on a new switch. These requirements must be met:

* MAC addresses must be learned dynamically

* Log messages must be generated without disabling the interface when unwanted traffic is seen

Which two commands must be configured to complete this task"? (Choose two)

SW(ccnfig-if)=switchport port-security mac-address sticky

SW(confKj-if)=switchport port-security violation restrict

SW(config.if)sswitchport port-security mac-address 0010.7B84.45E6

SW(config-if)aswitchport port-security maximum 2

SW(ccnfig-if)=switchport port-security violation shutdown

200-301 PDF/Engine

Get 65% Discount on All Products, Use Coupon: "ac4s65"