Summer Special Limited Time 60% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: 8w52ceb345

What is a requirement when configuring or removing LAG on a WLC?

Cisco 200-301 Full Course Access
Cisco 200-301 View All Questions

What is a requirement when configuring or removing LAG on a WLC?

A.

The Incoming and outgoing ports for traffic flow must be specified If LAG Is enabled.

B.

The controller must be rebooted after enabling or reconfiguring LAG.

C.

The management interface must be reassigned if LAG disabled.

D.

Multiple untagged interfaces on the same port must be supported.

200-301 PDF/Engine
  • Printable Format
  • Value of Money
  • 100% Pass Assurance
  • Verified Answers
  • Researched by Industry Experts
  • Based on Real Exams Scenarios
  • 100% Real Questions
buy now 200-301 pdf
Get 60% Discount on All Products, Use Coupon: "8w52ceb345"
Next
Refer to the exhibit.
A Cisco engineer must configure a single switch interface to meet these requirements• accept untagged...
Previous